Charge Base Plate, I/F Base Plate, Main Condenser And Other Small Parts; Dcdcak Base Plate - Nikon D300 Repair Manual

Charge base plate, I/� base plate, Main condenser
#1572
#1573×3
#614
#606×2
#B812
Black
Yellow
#1549×3
I/� base plate unit
・As shown in the illustration right above, mount the ���� base�plate fi�ing plate (#3��)
on the I/� base plate (#B1019). Then tighten the two screws (#1509).
・Connect the �PC (#1040) to the connector of the I/� base plate.
・Attach the GND plate (#3�7) by fitting it with the four bosses which are for
positioning the body.
・Mount the ���� base plate (#�1�1�) by fitting in the body�s groove and with two ���� base plate (#�1�1�) by fitting in the body�s groove and with two (#�1�1�) by fitting in the body�s groove and with two
positioning bosses. Then, tighten the two screws (#1543).

DCDCAK base plate

・As below, while folding and fitting the ��PC (#1�4�)
in the body boss, mount the DCDCAK base plate
(#1047) on the body.
・Tighten two screws (#1541) to (#1541) to
fi� �#1�47�. [#1047]. #1047].
#1040
and other small parts
#1638
#B602
#1012
�ilter base plate
DCDCSZ base plate
Black
Blue
DCDCAK base plate
ount the ���� base�plate fi�ing plate (#3��)
Blue
Yellow
Red
Black
I/� base plate
DCDCAK base plate
(#1047)
#1541
- Ａ  ・
#B326
After mounting the charge base plate, make
a mountain fold on the shutter �PC as above,
and fit with the boss of the charge base plate.
#B1067
#1029
#1564
-
logo Q0310 forGraphic
070509 Gdesign ito
INC
VBA20001-R.3720.A
Shutter �PC #B326
�PC as above,
#B1019
#397
#396
#1509×2
#1040
#1543×2
※ I/� base plate(#B1019)
soldering position
DI base plate
Brown
Yellow
DCDCAK base plate
Blue
Yellow
Red
Black
Green
DCDCSZ base plate
Black
�ilter base plate
Yellow
#1541
OP power base unit
Gray
Orange
Brown
Charge motor wire:Red
Charge motor wire:Black
make