Pd Base Plate/10-Pin Terminal - Nikon D300 Repair Manual

PD base plate/10-pin terminal

・Remove the ten solders of the wires that are connected to the PD base plate (#1002).
・Disconnect the FPC (#1010) from the connector.
・Take out the screw (#1522), and remove the PD base plate.
・Remove the solder of the lens release SW lug plate (#680) and also remove nine solders of the 10-pin terminal
(#41) (which is assembled from the other side and soldered).
・Take out the screw (#1503), and remove [#680] and the FPC (#1010).
・Take out the screw (#65), and remove [#41].
screw (#65), and remove [#41].
Black
Red
PD base plate
(#1002)
FPC: #1010
10-pin terminal (#41)(9 solders)
#1503
#1110
#1111
#957
[#41]. #41].
Blue
Brown
Yellow
#1119:Black
#1522
#680
#1010
#905
#968
- Ｄ  ･
Red
Green
Black
#1503
Lens release SW
#1522
lug plate (#680)
#1002
#991
#39
#65
-
logo Q0310 forGraphic
070509 Gdesign ito
INC
VBA20001-R.3720.A
AF motor wire
#1522×2
#1042
#41