Aaeon SBC-400 User Manual page 54

# of ports
2
2
1
1
Manual
If Manual is selected, the settings chosen by the end user in the
Peripheral Setup apply. WinBIOS will report any I/O conflicts after
display the BIOS Configuration summary screen.
This option enables the use of the floppy drive controller on the
motherboard (if installed). The settings are Enabled or Disabled.
This option enables the use of the IDE controller on the mother-
board, if installed. The settings are enabled or Disabled.
IRQ4 is used for the first serial port (COM1). This option enables
serial port 1 on the motherboard, if installed. The settings are
2E8h.
IRQ3 is used for the second serial port (COM2). This option
enables the serial port 2 on the motherboard, if installed. The
settings are 2E8h.
IRQ7 is used for the parallel port (LPT1). The IRQ can be changed
to IRQ5. This option enables the parallel port on the motherboard,
if installed. The settings are 278h.
This option specifies the parallel port Mode. The settings are
Normal or Extended.
port assignment
3E8h and 2F8h
3F8h and 3E8h
2F8h
3F8h
Chapter 3 AMI WinBIOS setup
onboard serial ort
3E8h and 3E8h
3F8h and Disabled
3F8h and Disabled
2F8h and Disabled
47