Using A Headset; Usb Devices - Panasonic KX-UTG300 Operating Instructions Manual

Installation and Setup

Using a Headset

If a headset is connected, you must enable Headset
mode by pressing [HEADSET].
Note
•
The Headset button light shows the current
status as follows:
Off: Headset mode off
Red: Headset mode on
For a Bluetooth Headset User
A Bluetooth headset can be used with the unit. Before
using the Bluetooth headset, you must enable
Bluetooth and connect the headset.
Connecting the Bluetooth headset
1.
On the Home screen, select
2.
Press [ ] or [ ] to select "Basic Phone Settings",
and then press [ENTER].
3.
Press [ ] or [ ] to select "Bluetooth", and then
press [ENTER].
4.
Press [ ] or [ ] to select "Enable Bluetooth", and
then touch
On
5.
Touch .
Scan
6.
A list of available Bluetooth devices is displayed.
Press [ ] or [ ] to select the desired Bluetooth
headset, and then touch
Note
•
is displayed in the Status bar when
Bluetooth is enabled.
•
is displayed in the Status bar when
Bluetooth is enabled and a Bluetooth device
is connected.
Receiving a call with the Bluetooth headset
1.
Press [HEADSET].
2.
To end the call, press [HEADSET] again.
Disconnecting the Bluetooth headset
1.
On the Home screen, select
2.
Press [ ] or [ ] to select "Basic Phone Settings",
and then press [ENTER].
3.
Press [ ] or [ ] to select "Bluetooth", and then
press [ENTER].
4.
Press [ ] or [ ] to select the Bluetooth headset, and
then touch
Disconnect
68 Operating Instructions
.
.
.
Connect
.
.
Deleting the Bluetooth headset
Delete the Bluetooth headsets that are no longer used
from the unit.
1.
On the Home screen, select
2.
Press [ ] or [ ] to select "Basic Phone Settings",
and then press [ENTER].
3.
Press [ ] or [ ] to select "Bluetooth", and then
press [ENTER].
4.
Press [ ] or [ ] to select the Bluetooth headset,
touch , and then touch
Delete
Switching from your Bluetooth headset to the
handset during a call
1.
Lift the handset off of its cradle.
Operating Distance
Please keep units containing Bluetooth modules 3 m or
more apart from each other. Also, if a Bluetooth headset
is in use near a telephone containing a Bluetooth
module other than the one it is registered to, noise may
be heard. To improve the signal, move away from the
telephone and closer to the one it is registered to.
Noise
Signals are transmitted between the unit and the
Bluetooth headset using radio waves. For maximum
distance and noise free operation, it is recommended
that the unit is situated away from electrical appliances
such as faxes, radios, personal computers, or
microwaves.
•
Systems using the 2.4 GHz ISM (Industrial,
Scientific and Medical) band may interfere with this
product. Examples of such systems are cordless
telephones, wireless LAN, Home RF, microwave
ovens and other ISM devices. These systems may
cause minor noise.
Notice
Operation is subject to the following two conditions:
1.
this unit may not cause interference, and
2.
this unit must accept any interference, including
interference that may cause undesired
operation of the unit. Privacy of
communications may not be ensured when
using the unit.

USB Devices

USB devices, including USB headsets and hubs, can
be connected to the USB port on the right side of the
unit (Page 13). If the KX-UTA336 is installed to the unit,
.
.
Yes
Document Version 2014-04