Usb Headsets; Usb Hubs; Setting Up The Unit; Maintaining The Unit - Panasonic KX-UTG300 Operating Instructions Manual

USB devices can be connected to the KX-UTA336
(Page 61).

USB Headsets

USB headsets can be used with the unit. See
Page 58 for information on supported headsets.
Note
•
Only 1 USB headset can be connected to the
unit at a time.

USB Hubs

A USB hub can be connected to the unit in order to
expand the number of devices that can be connected
to the unit. All supported USB devices can be
connected to the unit through a USB hub.
Note
•
Only 1 USB hub can be connected to the unit.
•
Depending on the number and type of devices
connected to a USB hub, an AC adaptor may
have to be connected to the USB hub in order
to power the connected devices.

Setting Up the Unit

The user settings can be used to setup the unit by
configuring the settings as required. See Page 39 for
information about the settings.
Document Version 2014-04

Maintaining the Unit

Resetting the Unit

Resetting all settings except for private
settings
Executing "Exclude Private Settings" resets all settings
except for private settings. Private settings include
ringtone volume, brightness, phonebook, and call
history.
1.
On the Home screen, select
2.
Press [ ] or [ ] to select "Reset", and then press
[ENTER].
3.
Press [ ] or [ ] to select "Exclude Private
Settings", and then press [ENTER].
4.
Touch .
Yes
•
To cancel, touch
Resetting all settings except for network
settings
Executing "Reset Excluding Network Settings" resets
all settings except for network settings. Private settings
and Bluetooth settings are reset in this case. Network
settings include IPv4, IPv6, LLDP Settings, CDP
Settings, VLAN Settings, Speed/Duplex, and Port
Mirroring.
1.
On the Home screen, select
2.
Press [ ] or [ ] to select "Reset", and then press
[ENTER].
3.
Press [ ] or [ ] to select "Reset Excluding Network
Settings", and then press [ENTER].
4.
Touch .
Yes
•
To cancel, touch

Restarting the Unit

When some of the settings on the unit have been
changed via Web user interface programming or
configuration file programming, the unit must be
restarted.
1.
On the Home screen, select
2.
Press [ ] or [ ] to select "Restart", and then press
[ENTER].
3.
Touch .
Yes
•
To cancel, touch
Installation and Setup
.
.
No
.
.
No
.
.
No
Operating Instructions 69