Paper; Paper Type - Kyocera Mita mita KM-P4850w Operation Manual

CHAPTER 3 GETTING READY FOR PRINTING

2. Paper

(1) Paper Type

Note the following restrictions on paper that can be used in this
machine.
G Compatible paper
1. Paper source 1 (option), paper source 2, and paper source 3
• Paper roll width: 17" to 36" [210 to 920 mm]
• Paper roll outer diameter: 6 3/4" [180 mm] or less
• Paper roll inner diameter: 3" [76 mm (75.2 to 77.2 mm)]
• Acceptable paper roll types
Plain paper (64 to 80 g/m 2 )
Vellum
Film
In case of Memory...
Paper length differs depending on the memory used for this Printer.
Available 128 MB
memory
3.0 ppm
printer
2.6 ppm
11" to 48"
printer
[297 to 1189
mm]
(as Standard)
2. Bypass
• Paper sizes (standard paper): 8 1/2" x 11" to 36" x 48"
[A4 portrait to A0]
• Paper width: 8 1/2" to 36" [210 to 920 mm]
• Paper length: 11" to 48" [297 to 1189 mm]
• Acceptable paper materials
Plain paper (64 to 80 g/m 2 )
Vellum
Film
G Unacceptable paper
• Paper other than the paper described in "G Compatible paper"
• Paper with staples, etc.
• If paper is wrinkled, folded or broken, unroll the paper until the
problem disappears and cut the paper before using it.
3-6
256 MB 512 MB
11" to 118" 11" to 236"
[297 to 3000 [297 to 6000
mm] mm]
(as Standard)
Not available Not available
G Automatic paper width detection
If the paper roll that has been set is of a standard size, the paper
width will be automatically detected. The following sizes can be
detected.
Inch specifications
<Architecture>
36"
30"
24"
18"
15"
12"
9"
<Engineering>
34"
30"
22"
17"
15"
11"
8 1/2"
NOTE
• Automatic detection will not function for the bypass.
• Paper width of non-standard sizes can be registered. See "1. Paper
width" in the default setting. (Page 5-6)
• For switching between standard sizes (architecture/engineering
[A sizes/ B sizes]), see "9. Standard size" in the default settings.
(Page 5-9)
G Storage of paper
If the machine is not used for an extended period time, remove the
paper roll and return it to its original packaging and reseal it.
IMPORTANT
• Vellum
Since vellum is very susceptible to its environment, when it is not
used, put it in a plastic bag and seal it.
• When using vellum at a high humidity or at a low temperature,
vellum will become fragile, resulting in wrinkles prints or missing
images. If images are not properly printed, perform the following
procedure.
* When using cut vellum:
Change the orientation of the paper (portrait or landscape).
* When using a vellum roll:
Unroll 1 length of paper and cut the paper before using it.
• When using roll paper whose surface is contaminated with
adhesive, remove the adhesive or unroll the paper until the adhesive
is no longer visible and cut off the unusable length.
Metric specifications
<A sizes>
A0: 841mm
A1: 594mm
A2: 420mm
A3: 297mm
A4: 210mm
<B sizes>
B1: 728mm
B2: 515mm
B3: 364mm
B4: 257mm