Configuring Machine Setting - Kyocera Mita mita KM-P4850w Operation Manual

CHAPTER 5 MANAGEMENT AND SETTING

(2) Configuring Machine Setting

G Configuration by user
1 Press the */Menu key.
2 Press the N or M key to select "2. Set/user".
Inch specifications
Menu:
2.Set/user.
Metric specifications
Menu:
2.Set/user
3 Press the Enter key.
4 Press the N or M key to select "1. Set machine".
Inch specifications
Set/user:
1.Set machine
Metric specifications
Set/user:
1.Set machine
5 Press the Enter key.
5-4
Press the N or M key to select a setting and press the Enter
6
key.
Inch specifications
Set Machine:
1.Paper width
Metric specifications
Set Machine:
1.Paper width
Configure each item, referring to the following pages:
1. Paper width···Page 5-6
2. Media Type [Pre-set Temp.]···Page 5-6
3. Paper type [Paper material]···Page 5-6
4. Roll end···Page 5-7
* The "*" in a list of setting options indicates the current
setting.
7 To configure another item, return to step 6.
To complete configuration, press the N or M key to select
"End" ["back"] and press the Enter key.
NOTE
• After each item has been configured, press the */Menu key to return
to the "Ready to print." screen.
• If you make a mistake when configuring an item, press the */Menu
key. The display will return to the "Ready to print." screen, leaving
the setting unchanged.
8 Press the N or M key to select "End" and press the Enter
key.