Daikin FXHQ32AVEB Installation Manual page 8

(3) Remove the parts of the indoor unit.
1) Remove the suction grille.
• Slide the suction grille fixing knobs (32 type: 2 places for each, 63, 100 type: 3 places for each)
toward backward direction (as shown by an arrow) to open the suction grille widely. (Refer to Fig. 4)
• Keeping the suction grille opened, hold the knob at the back of the suction grille and at the same
time, pull the suction grille forward to remove. (Refer to Fig. 5)
Fixing knob
2) Remove the decoration side panel (right, left).
• Remove the fixture screw of the decoration
side panel (one for each), pull forward (arrow
direction) to remove. (Refer to Fig. 6)
• Take out accessories. (Refer to Fig. 6)
• Open the knock hole at the wiring inlet side at
the rear surface or top surface, and install the
attached resin bushing (10).
Resin bushing (10)
(accessory)
3) Remove the hanger.
• Loosen 2 bolts for installing the hanger at both sides (M8) (4 places at left and right) within 10mm.
(Refer to Fig. 7 and 8)
• Remove the fixture screw for hanger at the back side (M5), pull the hanger backward (the arrow
direction) to remove. (Refer to Fig. 8)
Bolt (M8)
Loosen within10mm
Fig. 7
CAUTION
Do not remove the tape (milky white) applied to the outside of the indoor unit. It may cause electric shocks
or a fire.
7
Suction
grille
Fig. 4
Removable part (for leading
in from the top-surface)
Removable part (for leading
in from the rear-face)
Resin bushing (10)
(accessory)
Hanger fixing screw (M5)
Indoor unit
Hanger
Rear knob
Fixing screw for
decoration side panel
(M4)
Decoration side panel
Hanger installing
bolt (M8)
Hanger
Loosen
Fig. 5
Accessories
Fig. 6
Fig. 8
English