Daikin FXHQ32AVEB Installation Manual page 16

• Make sure to use the attached drain hose (1) and metal clamp (2). Also, insert the drain hose (1) into the
root of the drain socket, and tighten the metal clamp (2) at the root of the drain socket tightly.
(Refer to Fig. 25 and 26)
(Install the metal clamp (2) so that the tightening part is in the range of about 45°as shown in the Fig. 26.)
(Do not bond the drain socket and drain hose. If so, maintenance and inspection for the heat exchanger and
others cannot be conducted.)
CAUTION
If an old drain hose or an elbow or a clamp is used, it may cause water leakage.
• Bend the tip of the metal clamp (2) so that the sealing material does not bulge. (Refer to Fig. 26)
• When performing insulation, wind the sealing material (Large) (8) attached starting from the base of the
metal clamp (2) and drain hose (1) in the direction of the arrow. (Refer to Fig. 25 and 26)
approx. 45˚
Tightening
part
Bend the tip without
tearing the sealing
material (Large) (8)
• Be sure to insulate all drain piping running indoors.
• Do not deflect the drain hose (1) inside of the indoor unit. (Refer to Fig. 27)
(It may cause abnormal noise such as bubbling noise.)
(If the drain hose (1) is deflected, it may damage the suction grille.)
• Install supports at a distance of 1 to 1.5m so that the piping may not deflect. (Refer to Fig. 23)
CAUTION
To prevent dust from entering the indoor unit, cover the gap with the drain piping by putty or insulation (field
supply) so that no clearance is made.
However, when putting piping and remote controller wiring through the same hole, cover the gap between
the through cover and the piping after 8. ELECTRIC WIRING WORK is completed.
15
Metal clamp (2)
(accessory)
Drain hose (1)
(accessory)
Fig. 25
Metal
clamp (2)
(accessory)
Drain hose (1)
(accessory)
Sealing material
(Large) (8)
(For right back/
(accessory)
right side)
Sealing material (Large) (8)
(accessory)
Do not make a gap to avoid
dew condensation.
Sealing material
(Large) (8)
Applying direction
approx. 45˚
approx. 45˚
Inserting direction
for the screw driver
Do not deflect
Fig. 27
Metal clamp (2)
(accessory)
Drain hose (1)
(accessory)
Sealing material
(Large) (8)
(accessory)
(For left rear/
left side)
Fig. 26
English