Realignment - Kenwood TK-390 Service Manual

3. Self Programming
Write mode for frequency data and signalling etc. Mainly
used by the person maintaining the user equipment.
3-1. Enter to the self programming mode
Turn the power switch on, with the lead wire with plug
PF (8 pin) shorted to the E (10 pin) lead (Figure 4), or delete
R466 (SELF, Figure 5) in the TX-RX unit and turn the power
switch on while pressing the [Side 1] and [Side 2] keys.
Note :
This mode (self programming mode) cannot be set when
it has been disabled with the FPU.
Lead wire with plug
(E30-3287-08)
SCREW
TUBE
Fig. 4
X57-5400-10
Component side
Fig. 5

REALIGNMENT

2: RED (RX AF OUTPUT)
3: BLACK (RX AF OUTPUT)
5: WHITE (MIC INPUT)
6: BROWN (MIC GND)
7: BLUE (PTT SW) GND → ON
8: YELLOW (PF SW)
Shorted
10: BROWN (GND)
11: GREEN (5M)
E
TP4
TP5
When enter the self programming mode, "FUNC" appears
after "SEL" is displayed for half a second.
Selecting any of Channel setting, Group setting, Function
setting, or Clone master with the [Top 1] [Top 2] keys and
then pressing [PTT] sets the Setting mode for that time.
Key operations in Self programming mode are as follows.
[Selector switch] : Not used
[PTT] : Functions as a RUN or Execute key
[Top 1] : Use as a Down key
[Top 2] : Use as an Up key
[Side 1] : Use for select channel steps in Chan-
nel setting mode, or switching for
QT/DQT.
[Side 2] : Use as a cancel key
[Orange] : Add or delete frequencies in Channel
setting mode
[Toggle] : Flipping this to the right while in
Channel setting mode, shifts to MHz
steps.
Attach the lead wire with plug
or
[Side 1] + [Side 2] + Power on
TK-390
"SEL"
[PTT]
"CHAN"
[Top 1]
[Top 2]
[PTT]
"GROUP"
[Top 1]
[Top 2]
[PTT]
"FUNC"
[Top 1]
[Top 2]
[PTT]
"CLONE"
11