Kenwood TK-390 Service Manual page 15

TK-390
• Flow Chart
Self programming mode
Function setting mode
[Side 2]
[Side 2]
[Side 2]
[Side 2]
5. Minimum volume
[Side 2]
6. Battery warning on/off
[Side 2]
7. Busy LED on/off
[Side 2]
[Side 2]
9. Invert display on/off
[Side 2]
10. Priority 1 setting
[Side 2]
11. Priority 1 group selection
[Side 2]
12. Priority 1 channel selection
[Side 2]
13. Priority 2 setting
[Side 2]
14. Priority 2 group selection
[Side 2]
15. Priority 2 channel selection
[Side 2]
16. Revert channel
[Side 2]
[Side 2]
[Side 2]
14
REALIGNMENT
[Top 1] [Top 2]
[PTT]
1. Power on tone
[PTT]
2. Control tone
[PTT]
3. Warning tone
[PTT]
4. Alert tone
[PTT]
[PTT]
[PTT]
[PTT]
8. TX LED on/off
[PTT]
[PTT]
[PTT]
[PTT]
[PTT]
[PTT]
[PTT]
[PTT]
[PTT]
17. Squelch level
[PTT]
3-5. Clone Mode
1. Connect the cloning interface cable between the master
side transceiver (source) and slave side transceiver
(clone) as shown in the figure.
Cloning interface cable
Part No. E30-3325-05
2. Set the master side transceiver to Self programming
mode, and the transceiver display to "CLONE" with the
[Top 1] key or [Top 2] key and press [PTT].
[Top 1] [Top 2]
SEL CHAN
3. Set the power switch on the slave side transceiver to
ON.
4. The red LED on the master side transceiver flashes when
cloning starts and an "END" message appears when clon-
ing ends.
5. The green LED on the slave side transceiver flashes.
6. When a problem occurs during cloning, an "ERROR" mes-
sage appears on the master side transceiver.
7. Pressing the [Side 2] key sets clone mode.
Note :
The master transceiver copies only to type matched
slave.
• All Clone
1. Press [PTT] on the master side transceiver to start clon-
ing of all data except for the transceiver model type and
alignment data.
A CLONE
Red lamp flashes
CLONE
[PTT]
A CLONE
[Top 1]
[Top 2]
G CLONE
[PTT]
END