Automatic Buttonhole(Bh2/Bh3); Bh2 Sewing Steps; Bh3 Sewing Steps; Adjusting The Stitch Width And Density In Buttonholes 2 And 3 - Kenmore 385.19365 Owner's Manual

Automatic Buttonhole (BH2/BH3)
BH2 sewing steps
O Stitch pattern: BH2
(_ Thread tension dial: AUTO
® R: Automatic buttonhole foot
@ Starting point
(_ Barracking
* Sewing procedure is the same as BH1.
o BH3 sewing steps
O Stitch pattern: BH 3
(_ Thread tension dial: AUTO
® R: Automatic buttonhole foot
Q Starting point
(_ Barracking
* Sewing procedure is the same as BHlo
Note: See page 70 to make the hole of the key hole
buttonhole1
Adjusting the Stitch Width and Density in
Buttonholes 2 and 3
o To change the stitch density
The adjustment of the stitch density is between 0.2 to
0,8 the same as BHt° (refer to page 70)
1
o Adjustment of the stitch width on
buttonhole 2
When you press the zigzag width key, the pre-set
buttonhole width is set for the rounded buttonhole at
4,0, Press "+" or "-" to adjust the stitch width of the
entire buttonhole between 2,5 to 5.5.
Q Width: 2°5
@ Width: 4.0
® Width: 5.5
, Adjustment of the stitch width on
buttonhole 3
When you press the zigzag width key, the pro-set
buttonhole width is set for the keyhole buttonhole at 7.0.
Press %" or "-" to adjust the stitch width of the entire
buttonhole between 5°5 to 7_0,
Width: 5,5
® Width: 6.0
® Width: 7.0
8 %
--=--=
I AUTO R _" 7.00,4
®
=
m
AUTO 7.0
WIDTH
I
® ®
i
®
,J
h
72