Manual Stitch Length; Variable Needle Position - Kenmore 385.19365 Owner's Manual

Manual Stitch Length
Press "-" or "+" to adjust the stitch iength_
To decrease length, press "-".
To increase length, press "+'L
The pre-programmed stitch length setting is suitable for
most of your sewing needs. However, you can change
these settings to accommodate different fabric
characteristics or achieve a desired effect. Hold down "-'
or %" until you reach the desired setting.
* The reverse stitch length cannot be set longer than
1/8" (0.3 cm)
LENGTH
J !
I I ' ]
1
01 nuro :3,5
2.2
I
Variable Needle Position
These settings apply only to "straight" stitch patterns #1
through #3, #10, #1 t, #19, and #30°
When you select stitch patterns #1 through #3, #10, #11,
#19, and #30, (see bottom of box on right), you can adjust
the left/right needle position. When you press "-", the
needle position will move to the left.
When you press "+", the needle position wil! move to the
right.
O Left (0.0)
Middle (3°5)
(_ Right (7°0)
Note:
When using the straight stitch foot, make sure to use
center needle position (_.
Otherwise the needle may strike the sewing foot and
possibly break_
WIDTH
(-
I i
! !
I !
............ _01 _UTO :S.5
J
F
i
!
I
2.2
0 ® ®
Ill c _ I I:]
01 02 03 t0 I 1 18 30
50