Interior Installation - Hangar 9 Taylorcraft 26cc Assembly Manual

Drawing not to scale
Hangar 9 Taylorcraft 26cc BNF

4. When connecting the clevises to the rudder, make sure
there is a light amount of tension on the cables so the rudder
has no play at neutral so it will not flutter.
Rudder and elevator
Note: Always use threadlock on metal-to-metal
attach clevis
fasteners to prevent them from vibrating loose.
to this hole

5. Once the clevises are connected, use needle nose
pliers to tighten the nuts against the clevises to keep them
from vibrating and changing positions.

Interior Installation

Required Parts
Fuselage assembly Pilot
Pilot seat Painted plywood plate
2mm x 10mm washer head wood screw (4)
Required Tools and Adhesives
Phillips screwdriver: #1 Thin CA
Hook and loop tape or Zap-A-Dap-A-Goo

1. Locate the items to install the interior. You will also
need the fuselage assembly for this section of the manual.

2. Use a #1 Phillips screwdriver to install and remove one
of the 2mm x 10mm washer head wood screws in each of
the four mounting holes in the fuselage. This will cut threads
in the surrounding wood, preparing them for the next step.
19