Advertisement
47. Plug the 4-pin black connector of the i-VES
harness into the FM modulator.
4-PIN BLACK CONNECTOR
of i-VES HARNESS
i-VES HARNESS
WHITE JACK
48. Plug the red and white jacks of the i-VES
harness into the FM modulator.
49. The factory frequency setting for the FM
modulator is set at 88.3MHz.
NOTE: If the factory frequency setting is used by
a local radio station, pick an unused radio
frequency. Use the chart below to select a
frequency that is not used. Write down the new
frequency setting in the owner's manual supplied
with the i-VES, and notify the customer of the
change.
FM modulator frequency switch setting:
Adjust only switches 3, 4, and 5.
Factory
Default
88.1MHz 88.3MHz 88.5MHz 88.7MHz
5
5
4
4
3
3
2
2
1
1
88.9MHz 89.1MHz 89.3MHz 89.5MHz
5
5
4
4
3
3
2
2
1
1
12 of 14
FM
MODULATOR
i-VES HARNESS
FREQUENCY
RED JACK
ADJUSTMENT
SWITCH
5
5
4
4
3
3
2
2
1
1
5
5
4
4
3
3
2
2
1
1
50. Route the two leads of the FM modulator to the
console opening.
FM MODULATOR
FEMALE ANTENNA
LEAD
FM MODULATOR
MALE ANTENNA
LEAD
51. Connect the female antenna lead of the FM
modulator to the vehicle antenna lead.
52. Pull the male antenna lead from the FM
modulator out 80 mm through the radio opening.
53. Loop the excess FM modulator antenna cable,
and secure it with one wire tie.
Loop the antenna leads, and
secure them with one wire tie.
WIRE TIE
AII 22054 (0104)
VEHICLE ANTENNA
LEAD
FM MODULATOR
FM MODULATOR
© 2001 American Honda Motor Co., Inc - All Rights Reserved.
80 mm
Advertisement
