Customer information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by "do-it-yourselfers."
Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
Disconnect the negative cable from the battery.
Removing the Parts
Wrap the shop towel to the top of the flat-tip
screwdriver, and insert it to grooves in the audio
panel. Pull the audio panel out toward you to
release the five clips and remove the audio panel.
Take care not to damage the clips.
2 of 5
Remove the four washer-screws fastening the
audio unit to the instrument panel and pull the
audio unit out. Unplug the vehicle connector and
antenna lead from the rear of the audio unit and
remove the audio unit.
Remove the four screws and two self-tapping
screws fastening the right and left brackets to the
audio unit and pocket, and separate the pocket
from the audio unit. Save the pocket, screws and
brackets for your customer.
© 2003 American Honda Motor Co., Inc - All Rights Reserved.