Table of Contents
Advertisement
9.
For nonalcove installations, utilities and
venting can be connected after units are
stacked.
For alcove installations:
Securethe exhaust bracketto the rear of the
washerwith screwsprovided.
(See figures 14, 15& 16.)
Unsnaphosesfrom plastic hosecaddy,leaving
caddyattachedto the back of the cabinet.
Connectfill hoses to faucets (hotwater hose is
the left hose as you standfacing the front of the
washer). Insertthe drain hose in the stand pipe
recommendedheightof 36 inches,minimumof
24 inches. Note: If drain hose is not secure in
the standpipe, use a portionof the shipping
strapto securethe drain hose to the stand pipe.
Figure 14
Make sure that drain hose is securedto the hose
caddyafter installation. Fill hosesare not to
be securedto caddy. Turn on water and check for leaks.
Move unit into position,leveland tightenthe levelinglock nuts on the legs. Securethe vent pipe to the
exhaustbracket. (See figure 16.) MAKING SURE FIRST THAT OUTLET IS NOT ENERGIZED,plug
washer into outlet.
Figure 15
Figure 16
Page 12
Advertisement
Table of Contents
