Freezer Features; Primary Features; Drawers; Door Storage - Kenmore 596.500031 Use And Care Manual

Freezer Features
[ CAUTION l
To avoid property damage, observe the following:
• Do not force ice maker arm down or up
• Do not place or store anything in ice storage bin..
WARNING I
To avoid possible injury, including death, do not place glass
items in ice cream shelf Glass objects may shatter or
explode if exposed to extreme cold
iii i illlll
Ice Cream Shelf
tce cream shelf provides a space for items to be
chilled or frozen quickly
• To remove, lift ice cream shelf
from ice bin rails and pull
straight out.
• To install, fit shelf over top of
ice maker and lower onto ice
bucket rails
Primary Features
l,J
Automatic Dispensing Ice Maker
This ice maker creates the ice used in the dispensing
system
Using Ice Maker for the First Time
Confirm ice bin is in place
and ice maker arm is down.
After freezer section reaches
between 0 ° to 2°F (-18 0 to
-t7 ° C), ice maker fills with
water and begins operating.
Allow approximately 24 hours after installation to
receive first harvest of ice
Discard ice created within first 12 hours of operation to
verify system is flushed of impurities
Operating Instructions
Confirm ice bin is in place and ice maker arm is down
After freezer section reaches O° to 2°F (-18 ° to -t7 ° C),
Q
ice maker fills with water and
begins operating You will have a
complete harvest of ice
approximately every 3 hours
Stop ice production by raising ice
maker arm until click is heard
Ice maker will remain in the off position until arm is
pushed down
D rawe rs
Freezer Basket
To remove and install basket:
• To remove, lift front of basket
and pull out to its full
extension Lift up front of
basket and remove
. To install, slide basket into rails at bottom of freezer
section Lift up front of basket, and elide to the back of
unit
r
Ice Storage Bin
The ice storage bin is located below the automatic
dispensing ice maker
TO remove and install ice storage bin: I_
• TO remove bin, remove ice cream shelf I] "':'_ ....
Ra se ce maker arm tO deactivate ice ]I _'\
maker Lift front of bin and pull out _
to its full extension. Lift up front of " -r_
bin and remove
• To install, slide bin into rails below ice maker until bin
locks into place Drop ice maker arm to activate ice
maker, and replace ice cream shelf
IMPORTANT: Ice bin must be
Iocked in proper place for proper ,_ ,_ _
ice dispensing, If freezer door
does not close, bin is not in proper
location Turn auger driver counterclockwise (as shown)
to properly align ice bin with back of unit.
.............................. m
Shelves
mm =m= Hm4=
Freezer Shelf
To remove and install clip-mounted shelves:
&
To remove, pull shelf from wall _ A
mounting clips and pull left side _'_x_.l_-
of shelf out of wall mounting
holes _
• To install, place shelf in mounting hole and attach to
wall mounting clips
To remove
• To remove, snap dght side of
shelf from cabinet railing and
remove from wall mounting
clips
To install, replace shelf in
wall mounting clips Be sure back edge of shelf is
flush with back of cabinet and snap shelf into cabinet
railing
................................ .#
Door Storage
F
X
Door Buckets
Refer to refrigerator section for instructions
13