Setting Oven Controls; Setting The Clock; Changing Between 12Or24 Hourdisplay; Silent Control Operation - Kenmore 790.7752 Use & Care Manual

Setting Oven Controls
• Setting the Clock
• Changing between 12or24 hourdisplay
• Silent Control Operation
Setting the Clock
The CLOCK _'Q_ pad is used to set the clock. The clock may be
set for 12 or 24 hour time of day operation. The clock has been
preset at the factory for the 12 hour operation. When the range is
first plugged in, or when the power supply to the range has been
interrupted, the clock in the display will flash (See Fig. 1).
Fig. 1
INSTRUCTIONS
To set the clock
(example
below for 1:30):
1. Press (f_"). "CLO" will appear in the display (See Fig. 2).
2. Press
pads to set the time of day to 1:30
PRESS DISPLAY
Fig. 2
A
(See Fig. 3). Press (_ART). "CLO" will disappear and the clock
will start (See Fig. 4).
Changing between 12 or 24 hour time of day display:
1. Press and hold _Q_ for 6 seconds untill "12h" or "24h"
appears in the display.
Press _C_aX,_ to switch between the 12 and 24 hour time of day
2.
display. "12h" or "24h" will be displayed (See Figs. 5 or 6).
3. Press (_ to accept the desired change or press _ to
reject the change.
4. Reset the correct time as described in To set the clock above.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 00:00 through 23:59 hours.
Setting Silent Control Operation
(_for 6 seconds
orG
Fig. 3
Fig. 4
Fig. 5
Fig. 6
The DELAY START _tYy) and FLEX CLEAN (,.C_a_ pads control the Silent Control operation feature. The Silent Control
v
operation feature allows the oven control to be operated without sounds or beeps whenever necessary. If desired the control
can be programmed for silent operation and later returned to operating with all the normal sounds and beeps.
INSTRUCTIONS PRESS DISPLAY
To change control from normal sound to silent control operation:
1. To tell ifyour range is set for normal or silent operation press
and hold _ss_tY_ for 6 seconds. (See Fig. 7)
Press _ to switch between normal sound operation and
2.
silent operation mode. The display will show either "SP" (See
Fig. 8) or" ==" (See Figs. 2 or 3).
_for 6 seconds
If "SP" appears (See Fig. 2), the control will operate with normal
sounds and beeps. If "= -" appears (See Fig. 9), the control is
set for silent operation mode.
3. Press _ to accept the change or press Q to reject the _or_
change.
16
Fig. 7
Fig. 8
Fig. 9