Kenmore 790.4672 Use & Care Manual page 18

Setting Oven Controls (COB't)
Setting Continuous Bake or 12 Hour Energy Saving
The TIMER @ and FLEX CLEAN @ pads control the Continuous Bake or 12 Hour Energy Saving features. The
oven control has a factory preset built-in 12 Hour Energy Saving feature that will shut off the oven if the oven control is
left on for more than 11 hours and 59 minutes. The oven can be programmed to override this feature for Continuous
Baking. INSTRUCTIONS
To set the control for Continuous Bake or 12 Hour Energy
Saving features
1. Press and hold _ for 7 seconds (Figure1). After 7 seconds "12h" or"-
-h" will appear in the display and the control will beep once.
2. Press _ to switch between the 12 Hour Energy Saving and
continuous bake features. Note: "12h" (Figure 2) in the display indicates
the control is set for the 12 Hour Energy Saving mode and "- -h"
indicates the control is set for the Continuous Bake feature (Figure 3).
3. Press START to accept the change (Figure 4: display will return to
time of day) or press _ to reject the change.
PRESS DISPLAY
for 7
seconds
@
/ ........
START
or@
Figure 1
Figure 2
Figure 3
Figure 4
Setting Kitchen Timer
The TIMER _ pad controls the Kitchen Timer feature. The Kitchen Timer serves as an extra timer in the kitchen that
will beep when the set time has run out. It does not start or stop cooking. The Kitchen Timer feature can be used during
any of the other oven control functions. Refer to "Minimum and Maximum Control Pad Settings" for time amount settings.
INSTRUCTIONS
To set the Kitchen Timer (example: 5 minutes)
1.
PRESS DISPLAY
Press @. ..... --.-- will appear and "TIMER" will flash in the display @
(Figure 5).
2. Press the number pads to set the desired time in the display (example
Q G> .................
). Press The time will begin to count down with "5:00" and START
"TIMER" will stay in the display (Figure 6). Note: If is not
pressed the timer will return to the time of day after 25 seconds.
3. When the set time has run out, "End" and "TIMER" will show in the
display (Figure 7). The clock will sound with 3 beeps every 5 seconds @
until @ is pressed.
To cancel the Kitchen Timer before the set time has run out
Press _. The display will return to the time of day.
Figure 5
Figure 6
Figure 7
To Set Add 1 Minute Feature
The @ ADD 1 MINUTE pad is used to set the Add 1 Minute feature. When the @ pad is pressed, 1 minute is
added to the Kitchen Timer feature if this feature is already active. If the Kitchen Timer feature is not active and the
pad is pressed, the Kitchen Timer feature will become active and will begin counting down from 1 minute.
18