Download Print this page
Kenmore 79046763907 Installation Instructions Manual
Kenmore 79046763907 Installation Instructions Manual

Kenmore 79046763907 Installation Instructions Manual

30" electric slide in range

Advertisement

Available languages

Available languages

Quick Links

United
States
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIRED INSTALLER.
IMPORTANT."
SAVE FOR LOCAL ELECTRICAL INSPECTOR'S
USE.
READ AND
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasollne or other flammable
vapors and llquids in the vicinity of this or any other appllance.
These surfaces should be fiat
& leveled (hatched
area).
½"rain.
Shave Raised
Edge To Clear
Space for
31 5/16"
(81cm)
Wide
Cooktop
Rim.
Locate Cabinet
Doors 1" (2.5 cm)
Min. From Cutout
Opening
G
30" Min.
_m
13"
_J
30" Min. (see Note 3)
_
t
(76.2 cm) Min
(See Note 3)
18" Min.
._
17/8"
(4.8 :m)
F"
:
24" Min.
(61 cm) Mir
Grounded
Junction
Box or Wall
Outlet
Be Located 8"
to
17" (20.3 - 43.2 cm) From Right
Cabinet
and 2" to 4" (5.1=10.2 cm) From Floor
Do not install the unit in the cabinet
before
reading
next two pages.
35 7/8"
(91.1 cm) -
36 5/8"
(93 cm)
Printed
in Canada
30"
(76,2
cm)
31 5/16"
(79.5 cm)
28 5/16"
(71,9 cm)
30_+1/16"
(76,2+0,15
cm)
21 3/4"
(55,2
cm) Min.
22 1/8"
(56,2
cm) Max
24" (61 cm) Min. with
backguard
36 5/8"
(93 cm)
Max.
35 7/8"
(91.1 cm)
Min.
P/N 318201624
(1111) Rev. A
English - pages 1-12
Espa_ol - p6ginas
13-24

Advertisement

loading
Need help?

Need help?

Do you have a question about the 79046763907 and is the answer not in the manual?

Questions and answers

Summary of Contents for Kenmore 79046763907

  • Page 1 INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIRED INSTALLER. United States IMPORTANT." SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. FOR YOUR SAFETY: Do not store or use gasollne or other flammable vapors and llquids in the vicinity of this or any other appllance. 30"...
  • Page 2 NOTES: Do not pinch the power supply cord between the range and the wall. Do not seal the range to the side cabinets. 24" (61 cm) minimum clearance between the cooktop and the bottom of the cabinet when the bottom of wood or metal cabinet is protected by not less than 1/4"...
  • Page 3 To avoid breakage: Do NOT handle or manipulate the unit by the cooktop glass. The counter-top around the should be fiat and leveled cut-out (see hatched area on illustration Before installing the unit, measure the heights of the two (2) cabinet sides (H1-4), front and back (see illustration 1) from...
  • Page 4: Important Safety Instructions

    the Standard for Manufactured Home installation Important Notes to the installer 1982 (Manufactured Home Sites, Communities Read all instructions contained in these and Setups), ANSI Z225.1/NFPA 501A-latest installation instructions before installing range. edition, or with local codes. Remove all packing material from the oven and •...
  • Page 5: Power Supply Cord Kit

    Power Supply Cord Kit This appliance is manufactured The user is responsible for connecting the power with the frame grounded by connection of a supply cord to the connection block located behind grounding strap between the neutral power supply terminal and the frame.
  • Page 6 Silver colored Terminal Direct Electrical Connection to the Circuit Breaker, Fuse Box or Junction wi re If the appliance is connected directly to the circuit breaker, fuse box or junction box, use flexible, armored or nonmetallic sheathed copper cable Terminal (with grounding wire).
  • Page 7 Where local codes DO NOT permit Cabinet Construction connecting the appliance-grounding conductor to the neutral (white) wire, or if To eliminate the risk of burns connecting to 4-wire electrical system (see or fire by reaching over heated surface units, do Figure 6): not have cabinet storage...
  • Page 8: Standard Installation

    Range Installation Slide the range into the cutout opening Important Note: Door removal is not a requirement center it before leveling for installation of the range, but is an added convenience. Level the range (see section 5). The floor the range is to be installed must be level.
  • Page 9 lf Accessories Needed installation With Backguard A backguard kit can be ordered through a Sears Service Center.The cutout depth (2t 3/4" (55.2 cm) Min., 22 1/8" (56.2 cm) Max.) needs to be increased to 24" (61 cm) when installing backguard Installation With End Panel An end panet kit can be ordered...
  • Page 10 Decorative Rear Trim Installation Operation of Oven Elements The oven is equipped with an electronic oven required) control. Each of the functions has been factory Disconnect the power from the range. checked before shipping. However, it is suggested Make sure the range is leveled. that you verify the operation of the electronic oven...
  • Page 11 Draw a center line (CL) on the floor where the Anti-Tip Brackets Installation range should be installed. Also draw a line on the floor at the range back position if there is no Models Equipped with Leveling Device wall. To reduce the risk of tipping of the Unfold paper template and place it fiat on the...
  • Page 12 C. Level and position the rang_e_ = Slide range to its Anti-Tip Bracket Installation final position, insert the range leveling leg in the anti- tip bracket. Visually verify if the anti-tip bracket is Models Equipped with LevelincLLeLecj3_ engaged. Lower the range by adjusting the 4 leveling reduce the risk of tipping of the...
  • Page 13 LA INSTALACION Y EL SERVICIO DEBEN SER EFECTUADOS POR UN Estados Unidos I NSTALADOR CALIFICADO. IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA USO DEL INSPECTOR LOCAL DE ELECTRICIDAD. LEA Y GUARDE ESTAS INSTRUCCIONES PARA REFERENCIA FUTURA. PARA SU SEGURIDAD: No almacene nl utilice gasoHna u otros vapores y liquidos inflamables...
  • Page 14 NOTA: No peiiizque el@ctrico conducto flexible de gas entre ia estufa y pared. el cord6n o el estufa a los armarios de lado. 2Is/_'' seJJe Ja Un espacio mfnimo de 24" (61 cm) entre la superflcie de la estufa y el rondo del armario cuando el rondo del armario...
  • Page 15 Para evitar ffactura de la unidad: NO manipule unidad sosteniendo ia cubierta de vidrio. La cubierta alrededor del espacio donde us'red ins,ralara su unidad debe de es,rar plana y nivelada. (Vea el 6rea sombreada en la ilus,rraci6n n0mero Antes de ins,ralar la unidad, mida la al,rura de los dos (2) lados de los gabine,res...
  • Page 16 Notas importantes para el instalador Safety Standard, fituto 24CFR, parte 3280 [antiguamente ta Federal Standard for Mobile 1. Lea todas las instrucciones antes de instalar la Home Construction and Safety, fituto 24, HUD cocina. (parte 280)] o cuando este c6digo no se aptica, 2.
  • Page 17 Estuche de cable del suministro el_ctrico Este electrodam_stlco fabricada can el marca aterrlzada a tray,s de una El utilizador es responsable de la conexi6n del carrea de canexi6n entre el neutral de la fuente cable del suministro el6ctrico al btoque de conexi6n de allmentaci6n y el marca.
  • Page 18 Terminal plata Btoque terminal Terminal plata Alambre Atambre Rojo Btoque terminal Alambre Necjro Atambre de ta conexi6n Necjro directa. Retira la arandela pre- cortada para 3/8" (3.5 cm) dia. acjujero. Una arazadera Una arazadera (2.9 cm) Acjujero releva provista debe releva provista debe...
  • Page 19 Cable de la fuente Construcci6n del armario aNmentaci6n Para etiminar et riesgo Alambre neutro /"_-_'_ /_,lamlores e quemaduras o de fuego tratando de alcanzar (btanc_._..j ,n_r negros algo por encima de las zonas calientes, evite r°J°_ _'i _" _/_///\W colocar artfcutos sobre la cocina.
  • Page 20 necesario, tevante la unidad bajando las paras de lnstalaci6n de la estufa nivelaci6n. Nota importante: Deslice ta unidad hacia el gabinete y central es necesario, pero si antes de nivelarta. es conveniente, quitar la puerta para instalar Nivele la cecina (vea Nivelaci6n de la el horno.
  • Page 21 Si se necesltan los accesarla InstaJaci6n can el repuesto La profundidad del carte de (21 3/4" (55.2 cm) Min., 22 1/8" (56.2cm) Max.) necesita ser aumen- tada a 24" (61 cm) cuando instala el repuesto. Instalaci6n de una maJdura trasero. La moldura trasera puede ser pedida...
  • Page 22 Funcionamiento de los Elernentos del Homo Instalaci6n de Accesorio Decorativo Et horno est6 equipado con un control electr6nico. Trasero (si se requiere) Cada funci6n ha sido probada en la f6brica antes Desconecte la alimentaci6n del aparato. del transporte. Sin embargo, sugerimos que Ud.
  • Page 23 Dibujar una linea central en el piso donde se Instrucciones de instalaci6n de la fljaci6n instalar6 la cocina. Si no hay pared posterior, anti-inclinaci6n dibujar otra linea en el piso que corresponda Para los modelos ecluipado con un la parte posterior de la cocina. sistema de dispositivo de nivelaci6n°...
  • Page 24 C. Nivele la coclna y coloque la coclna en su lucjan - Instrucci6n para la instalaci6n de las Desiice la estufa a su lucjar. Colocar la pata niveladora fijaciones de anti-inclinaci6n dentro de ia fijacione de anti-inclinaci6n. Verifique visualmente que las fijaciones de anti-inciinaci6n estSn Para los modelos equipado...