Kenmore 790.4672 Use & Care Manual page 11

Setting Surface Controls (¢ont'd)
Operating the Dual Surface Element
The cooktop is equipped with a Dual radiant surface
element located at the right front cooktop position (Figure 1).
Indicator lights on the control panel at that position are used
to indicate what portions of the Dual radiant element will
heat. The INNER light indicates that only the inner element
will heat (Figure 2). The OUTER light indicates that both
inner and outer elements will heat together (Figure 3). You
may switch between these different settings at any time
during cooking.
Figure 1
OUTER (_
@_ INNER
Figure 2
qlP OUTER
_,o INNER
To Operate the Dual Surface Element:
1. Place correctly sized cookware on the radiant surface element.
Figure 3
2.
Touch and hold the pad for the Dual element position until a beep is
heard. The display will show " - - ". Note: If no further pads are touched within
10 seconds the request to power the element ON will clear.
3. If the pan sensing feature is off, select the INNER (Figure 2) or OUTER (both
.. E LE M-"_"_rr .
elements) (Figure 3) to heat by pressing tne _ paa once or twice times
(Figures 3 & 4 show indicator lights with OUTER selected). Note: If no
element size is chosen when the dual element is turned ON, the control will
default to the inner coil only. If the pan sensing feature is on, the element size
key is disabled and the appropriate element size is automatically selected
according to the pan size.
Touch HI _ pad once to turn ON the power level to HI. Touch Lo
4.
pad once for Lo (See Figure 4).
Each touch of the HI _'_ or Lo _ pad will increase or decrease
5.
power
levels from 9.5 through 3.0 by .5 increments. Simmer power levels between
3.0 and 1.2 will decrease or increase by .2 increments. Lo is the lowest power
level available.
Note: The power level may be adjusted at any time while the element is ON.
A :,
Lo
@ _ OUTER
UI;
:;:II:::C[
@ _ INNER
S Iz E
6.
When cooking has been completed touch the pad once to turn the Figure 4
entire element OFF.
Each dual surface element provides a constant amount of heat at each setting. The different glow of the 2 elements
is normal and doesn't affect heating performance (See Figure 3). A glowing red surface heating area extending
beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area.
Note: If no element size is chosen when the dual element is turned ON, the control will default to the inner coil only. See
page 9 for recommended surface cooking settings.
Radiant surface elements may appear to have cooled after they have been turned off. The glass surface
may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.
Do not place aluminum foil or plastic items such as salt and pepper shakers, spoon holders or
plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or
wooden spoons could catch fire if placed too close to the surface elements.
11