Table of Contents
Advertisement
Chapter 11. Run mode features
Before we continue with the run mode features, please make sure that you have programmed some
sequences, cue scenes and playback scenes. You need at least 5 of each to properly follow examples in
this chapter.
11.1 Sequence transparency across cues
Sequence transparency is default ON. You can switch it OFF in the setup menu.
11.1.1 Transparency enabled
Cue 1
A: SEQ1
B:
C:
D: SEQ3
CS1
Launch cue1:
•
SEQ1 starts running on layer A.
•
SEQ3 starts running on layer D.
•
CS1 starts running on the cue scene level.
Launch cue2:
•
There is no sequence in layer A; SEQ1 from cue1 will keep running.
•
SEQ2 starts running on layer B.
•
SEQ4 replaces SEQ3 from cue1 because they are both on layer D.
•
CS2 replaces CS1 from cue1 because they are both on the cue scene level.
The following processes are running as a result of cue1 followed by cue2:
•
SEQ1 is running on layer A.
•
SEQ2 is running on layer B.
•
SEQ4 is running on layer D.
•
CS2 is running on the cue scene level.
Cue 2
A:
B: SEQ2
C:
D: SEQ4
CS2
Martin Xciter user manual
running processes
A: SEQ1
B: SEQ2
C:
D: SEQ4
CS2
Run mode features
47
Advertisement
Table of Contents
