Ethernet; Network Diagnostic; Network Bandwidth - COMPRO TN1500 User Manual

Compro TN1500/TN1500W

Ethernet

Choose the IP address configuration. The camera can obtain IP address via DHCP (recommended), use the
manually inputted static IP address, or obtain IP address via PPPoE for which you need to provide valid user
name and password.

Network Diagnostic

Here you can run the diagnostic tool for your current network settings and it will show error messages if any
anomaly is detected. For further information on error messages, please refer to the FAQ section in this manual
or visit www.comprosecurity.com for more information.

Network Bandwidth

This automatic network connection speed test is to help users better define appropriate video bit rate for
their applications. To perform network bandwidth test:
1. Go to [Setup] > [Network], and click on [Network Bandwidth] located on the left menu to start.
2. Wait for Internet Explorer to prompt for the installation of Java plug-in. Then click on the text to accept.
3. Camera begins testing connection speed.
4. Once speed diagnostics is done, camera will advise on current network connection speed. See below
example:
The message indicates that currently connected network has the network capacity to support up to 10
network cameras of identical bit rate settings (either on Stream 1 or Stream 2). If the message shows a less
favorable result, go to [Setup] > [Video] to select a lower current video bit rate setting
6-6 Network Settings
Figure 6-8. Network settings