Yamaha DT230 Owner's Manual page 84

1
1. Swingarm end bolt (×2)
3. Remove the swingarm end bolt
from each end of the swingarm.
PERIODIC MAINTENANCE AND MINOR REPAIR
4. Push the wheel forward, and
then remove the drive chain from
the rear sprocket.
NOTE:
The drive chain does not need to be
disassembled in order to remove and
install the rear wheel.
5. Remove the wheel.
cC
Do not apply the brake after the
wheel has been removed together
with the brake disc, otherwise the
brake pads will be forced shut.
6-41
To install the rear wheel
1. Install the drive chain onto the
rear sprocket, and then insert the
wheel axle from the left side.
NOTE:
Make sure that there is enough
space between
before inserting
between the pads.
2. Install the swingarm end bolts,
and then lower the rear wheel so
that it is on the ground.
3. Adjust the drive chain slack.
(See page 6-26 for drive chain
slack adjustment procedures.)
4. Tighten the
swingarm end bolts to the speci-
fied torques.
ECA00048
Tightening torque:
Axle nut:
103 Nm (10.3 m
Swingarm end bolts:
3 Nm (0.3 m
EAU01806
1
2
3
the brake pads
the brake disc
4
5
6
7
axle nut and
8
9
0
kg)
0 kg)