Starting A Warm Engine; Shifting - Yamaha DT230 Owner's Manual

OPERATION AND IMPORTANT RIDING POINTS
NOTE:
If the engine fails to start, release the
start switch, wait a few seconds, and
1
then try again. Each starting attempt
should be as short as possible to pre-
2
serve the battery. Do not crank the
engine more than 10 seconds on any
3
one attempt.
4
6. After starting the engine, move
the starter (choke) knob/lever
back halfway.
5
cC
6
For maximum engine life, never
accelerate hard when the engine is
7
cold!
8
7. When the engine is warm, turn
the starter (choke) off.
9
NOTE:
The engine is warm when it responds
normally to the throttle with the starter
(choke) turned off.

Starting a warm engine

Follow the same procedure as for
starting a cold engine with the excep-
tion that the starter (choke) is not
required when the engine is warm.
ECA00045
EAU01258
1. Shift pedal
N. Neutral

Shifting

Shifting gears lets you control the
amount of engine power available for
starting off, accelerating, climbing
hills, etc.
The gear positions are shown in the
illustration.
NOTE:
To shift the transmission into the neu-
tral position, press the shift pedal
down repeatedly until it reaches the
end of its travel, and then slightly
raise it.
5-2
6 1
5
4
3
2
N
1
EAU00423