Indicator And Warning Lights - Yamaha DT230 Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
1 2 3
1
2
3
1. Oil level/coolant temperature warning
4
light "WARNING"
2. Oil level symbol "
7
3. Coolant temperature symbol "
5
4. Turn signal indicator light "5"
5. High beam indicator light "&"
6. Neutral indicator light "N"
6

Indicator and warning lights

7
Oil level/coolant temperature
8
warning light "WARNING"
This warning light has the following
9
three functions.
8 When the engine oil level is low,
the warning light comes on and
symbol " " flashes. If this
7
occurs, stop the engine immedi-
ately and add engine oil to the
specified level.
8 When the coolant temperature is
4 5
too high, the warning light comes
on and symbol "
Stop the motorcycle and allow it
to idle until the coolant tempera-
ture goes down. If the tempera-
ture does not go down, stop the
6
engine. (See the "Engine over-
heating" section on page 6-44 for
further instructions.)
8 When the engine oil level is low
"
"
and the coolant temperature is
too high, the warning light flash-
es and symbols "
EAU03034
come on.
To check that the warning light is
EAU03587
working properly:
8 Put the transmission in neutral or
apply the clutch lever.
8 Turn the engine stop switch to
"#" and the key to "ON".
8 The light will come on and sym-
bol "
play.
" flashes.
" and "
7
" will appear in the dis-
7
3-2
If the warning light does not come on,
have a Yamaha dealer inspect the
electrical circuit.
cC
8 Do not operate the motorcycle
until you know that the engine
oil level is sufficient.
8 Do not operate the engine if it
is overheated.
NOTE:
Even if the oil is filled to the specified
level, the indicator light may flicker
"
when riding on a slope or during sud-
den acceleration or deceleration, but
this is normal.
Turn signal indicator light "5"
This indicator light flashes when the
turn signal switch is pushed to the left
or right.
EC000118
EAU00057