Advertisement
LP Tank Exchange
• Many retailers
that sell grills
offer you the op-
tion of replacing
your empty LP tank through an
exchange
service.
Use only those
reputable
exchange
companies
that
inspect,
precision
fill, test and certify
their
cylinders.
Exchange
your tank only for an OPD safety feature-equipped
tank as described
in the LP Tank section
of
this manual.
• Always
keep new and exchanged
LP tanks in
upright
position
during
use, transit
or storage.
• Leak test new and exchange
LP tanks BEFORE
connecting
to grill.
LP Tank Leak Test
For your safety
• Leak test must be repeated
each time LP tank is
exchanged
of refilled.
• Do not smoke during
leak test.
• Do not use an open flame to check for gas leaks.
• Grill must be leak tested outdoors in a well-ven-
tilated
area, away from ignition
sources such as
gas fired or electrical
appliances. During leak test,
keep grill
away from
open flames
or sparks.
• Use a clean paintbrush
and a 50/50 mild soap
and water solution.
Brush soapy solution
onto
areas
indicated
by arrows
in figure
below.
WARNING
If growing bubbles appear do not use or move
the LP tank. Contact an LP gas Supplier or your
fire department!
Basic Lighting
Procedures
Machine oils used in the manufacturing process of
stainless steel can cause stainless steel to turn a tan
color. Before initial grill use, remove protective PVC film
from Control Panel and inside and outside of Grill Lid.
Use a Stainless Steel Cleaner to polish the stainless steel
and remove these excess oils from your grill. Never use
abrasive cleaners or scrubbers because they will scratch
and damage your grill. For details, see Cleaning Exterior
Stainless Steel Surfaces on page 27.
Gas Lighting Instructions
Familiarize yourself with the safety guidelines at the
front of this manual. Do not smoke while lighting grill
or checking gas supply connections.
1.
If you have a LP gas grill be sure the LP gas tank
is filled, or if you have a NG grill be sure that the
locking shut off valve is open.
2. Check that the end of each Burner Tube is
properly located over each Valve Orifice.
3. Be sure all gas connections are securely tightened.
4. Open the Grill Lid or Side Burner Lid, depending
on the Burner you are lighting.
Z WARNING
Failure to open Grill Lid during the
lighting
procedures
could result in a fire
or explosion
that could cause serious
bodily injury, death, or property damage.
5. Set ALL Control Knobs to OFF and open the LP
Gas Tank Valve slowly until 1/4 to 1/2 open.
Open LP
Gas Tank
T
OFF
• Do not use household
cleaning agents.
Damage
to gas assembly
components
can result.
24
6. Push and turn the any Control Knob for Main
Burner to HIGH.
HI
OFF_
LEFT
ELECTRIC
iGNITOR
MAIN
BURNER
Advertisement
