Advertisement
[]
Ignitor Battery Installation
- See Fig. 9
1. Remove the Ignitor Caps on the grill Control
Panel.
2. Place the manufacturer
supplied
AA battery
into Ignitor Slot. Be sure to place the positive
pole facing toward you. See Figure
9.
3. Place the Cap and Spring over the AA battery
then tighten the Ignitor Cap back onto the grill
Control Panel.
4. Remove any protective film from outside and
inside of Grill Head.
IMPORTANT:
Before use of this grill please
refer to Cleaning
Exterior Stainless
Steel
Surfaces
found on page 27 of this Owner's
Manual.
Figure 9
IGNITOR
SLOT
[]
Electrode
Check - Requires an Assistant
Before placing the cooking components
into your
grill, ensure that the Spark Electrode Tip is properly
positioned within each Gas Collector Box ( a
3-1/4" wide stainless mechanism found at the front
between each set of Burners.) The easiest way to
ensure this is to perform this Electrode Check:
1.
Be sure all Control Knobs are set to "OFF"
and open the Grill Lid.
2.
Have an assistant stand behind to the right of
the grill and look down at each Gas Collector
Box. NEVER put your face inside Grill Head.
.
Press the Ignitor Cap. You should
hear a
"clicking"
sound and your assistant
should see
a small blue spark within each Gas Collector
Box. If a spark is present the Electrode Tips
are properly positioned.
4.
if no spark is seen the Spark Gap shown in
Figure 10 needs to be adjusted as follows:
Using an adjustable
wrench, loosen the inside
Nut just until the Gas Collector
Box can be
maneuvered
and turned upward.
The gap between the Spark Electrode Tip and
Spark receiver should be approximately
3/16".
If the gap is wider than 3/16" use a pair of long
nose pliers and gently squeeze the Gas Collector
Box until the gap is correct.
Return the Gas Collector Box to its original
horizontal position, secure the Inside Nut and try
the Electrode Check again.
5.
If no "clicking" sound is heard check the following
common causes. If you need assistance call our
Grill Information
Center
at 1-888-317-7642.
•
IgnitorAA battery not installed properly.
Electric wires may be loose. Remove the AA
battery, inspect the Ignitor Junction Box found
behind the Control Panel, and connect any loose
wires.
Figure 10 - Side View Figure
GAS COLLECTOR
BOX
\\
iNSiDE
NUT
\
SPARK
GAP
_SPARK
RECEIVER
19
Advertisement
