Advertisement
6. For Natural Gas grills:
Connect the Electric Wire terminal from Side Burner
with the other from Grill Head. See Figure 8d. Bind
the connected Electric Wires, and Connection Tube
together using the supplied Fastening Band.
7. The gap between the Side Burner Electrode Tip and
the Side Burner Port should be approximately
1/8"~3/16". See Figure 8e. If the gap is wider than
3/16", use a pair of long nose pliers and gently
bend the Electrode Tip toward the Burner.
8. Slide the 5 Tool Hooks onto the Tool Holder with
hooks facing the grill Head. Attach Tool Holder
to left side of Side Shelf and secure firmly using
2 of the M5x8mm
Pattern
Head Screws
and
washers supplied. See Figure
8f.
• When you have finished
assembling
your
grill we strongly
urge that all Pattern
Head Thumb
Screws be tightened,
either
with the supplied Tightening
Tool or a
#2 Phillips Head Screwdriver.
Tightening
Tool
Ref. # P05515102K
Figure 8d (Natural
Gas model only)
SIDE
BURNER
POT
SUPPORT
\\\\\
_StDB
BURNER
CONTROL
KNOB_
FASTENING
BAND
COTTER
PIN
\
SiDE BURNER
FRAME
_StDE
BURNER
GAS
VALVE ASSEMBLY
_
ELECTRIC
WIRE
FROM
SiDE
BURNER
\
\
\
ELECTRIC
WIRE
FROM GRILL HEAD
Figure 8e
1/8"-3/16"
BURNER
PORT
9.
For Natural
Gas grills:
Connect the hose end of the 12' Natural Gas
Hose to the vertical
fitting as shown in Figure
8g. Also read the natural gas safety instruc-
tions. (on page 4)
Figure 8g (Natural
gas model only)
FOOT
\SIDE BURNER
BRASSADAPTOR,
f
SIDE
BURNER
GAS
VALVE
12' NATURAL GAS HOSE
Figure 8f
TOOL
HOLDER
TOOL
HOOK
CONNECTION
TUBE
FROM GRILL
HEAD
M5x8rnm PATTERN
HEAD SCREW
SiDE SHELF
18
Advertisement
