Sargent P2 PASSPORT 1000 Installation Instructions Manual page 12

11 Install Outside Escutcheon with (Optional) Gasket
Note: Gasket optional, for non-fire rated doors only.
For non-fire rated door applications, an optional gasket
(Part number 52-0782) may be used as a weather seal
between the escutcheon and the outside door surface.
Peel off adhesive backing and attach to (outside) escutcheon.
1. Position the outside escutcheon, aligning the posts with
the door prep (Fig. 10).
2. On the inside of the door, position the mounting plate
over the indicated holes.
3. Feed reader cable through opening.
4. The cable from the lockbody feeds from the bottom.
12 Mounting Plate Assembly
1. On the inside of the door, position the mounting plate over the
indicated holes.
2. Feed lockbody, controller and DPS cables through central open-
ing (Fig. 12A and 12B).
3. Route ground ring terminal from lock body under bottom of
mounting plate and attach to bottom left corner using one #8-32 x
1-7/8" flat head machine screw.
4. Insert other three #8-32 x 1-7/8" flat head machine screws and
tighten, fastening the outside escutcheon to the door (Fig. 12A).
12 1-800-810-WIRE • www.sargentlock.com • A8013F
Passport 1000 P2 WiFi Cylindrical Lock
Outside
Escutcheon
Gasket
Fig. 10
Position ground
ring terminal
upright, then
tighten screw.
Fig. 11
Outside of Door
Reader
Cable
Mounting Plate
(4) #8 - 32 x 1-7/8" Flat
Head Machine Screws
(2) #8 - 3/8" flat head
Wood Screws