Table of Contents
Advertisement
HOW TO REMOVE, CLEAN OR INSTALL A
NEW FILTER
1. Lift the filter up so the bottm clears the
lower filter retainer.
2. Pull the bottom of the filter out while
pushing down until the top of the filter
clears the upper retainer. If the unit is
operating, carefully remove it assuring
no dirt from the filter enter the air
intake opening.
3. Follow the cleaning instructions shown
in the graphic below.
4. Look at the air flow arrows on the
filter for correct installation direction.
Reinstall the cleaned filter (or a new
filter) by sliding the top of the filter up
into the upper retainer while pushing it
against the unit. Finally, slide the filter
down into the lower retainer.
For replacement filter, disposable filters and filter adhesive, see parts list in Table 1 on page
12
- 10 -
RP aluminum washable air lters are designed to provide
excellent ltering e ciency with a high dust holding capacity
and a minimum amount of resistance to air ow. Because they
are constructed entirely of aluminum, they are light weight
and easy to service. Optimum
maintained by recoating the lters after washing with RP
Super Filter Coat adhesive. To achieve maximum performance
from your air handling equiment, the air lter should be
cleaned on a regular basis.
1. Flush the lter with warm water from the exhaust
side to the intake side. DO NOT use caustics.
2. After ushing, allow lter to drain. Placing it with
a corner down will assure complete drainage.
3. Recoat the lters with RP Super Filter Coat
adhesive by dipping or spraying. If the lter is
sprayed, do so from both sides for maximum
concentration of adhesive.
© 2013 Pentair Equipment Protection
lter performance is
87976428
Advertisement
Table of Contents
