Add Fingerprint; Delete Fingerprint; Fingerprint Status; Areas - Bosch Solution 144 User Manual

Solution 144 User Guide
Access > Fingerprint >

Add Fingerprint

This menu allows a master user to add a new fingerprint
for users that have been assigned to the same area(s) as
the Master user.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [1] + [2] + [0].
A list of users will display on the keypad.
2. Use the [] and [] keys to select the user that you
want to add a a fingerprint for, then press [OK] to
select.
Ur1 John Smith
Ur2 Debbie Smith
Ur3 User 3 Name
Press

3. The system will prompt you to present the finger
to the reader. If more than 1 fingerprint reader is
installed then the system will prompt you to select
the reader to learn from.
Fr9 Keypad 9 Name
Fr10 Keypad 10 Name
Fr11 Keypad 11 Name
Press

4. You must hold your finger on the reader without
moving until you hear a confirmation beep which
could take up to 5 seconds.
Position Finger for Ur1
John Smith at Fr9
Press OK or MENU
5. A Master user can only delete a fingerprint of a user
that has been assigned to the same area(s) as the
Master user.
Only one fingerprint can be assigned to each user.
i
To change a fingerprint for an existing user, you will
Note
need to first delete the old fingerprint first.
Access > Fingerprint >

Delete Fingerprint

This menu allows a Master user the ability to delete a
fingerprint for those users that have been assigned to the
same area(s) as the Master user.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [1] + [8] + [1].
A list of users will display on the keypad.
2. Use the [] and [] keys to select the user who's
fingerprint you want to delete, then press [OK] to
select.
16
MENU 1-8-0
OK or MENU
OK or MENU
MENU 1-8-1
Ur1 John Smith
Ur2 Debbie Smith
Ur3 User 3 Name
Press

The keypad will display;
To delete Fingerprint for
Ur1 John Smith Press OK
Press OK
Press OK or MENU
3. When prompted press the [OK] key to confirm
fingerprint deletion.
Access > Fingerprint >

Fingerprint Status

This menu allows a master user the ability to identify a
fingerprint which has been programmed into the system.
Only fingerprints that have been assigned to the same
area(s) as the Master user can be identified.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [1] + [8] + [2].
The system will prompt you to present the finger to
the reader.
Position Finger at
Fr9
Press OK or MENU
2. Once the presented the system will display the user
assigned to the fingerprint.
Finger belongs to Ur1
John Smith
Press OK or MENU

Areas

The control panel has the ability to be partitioned up to
8 individual areas. This section outlines various commands
that control individual areas.
Areas > Commands >

Area Status

This menu allows users the ability view the area status of
the current area or the status of a different area. This menu
is only available via a keypad who's corresponding area is
turned off.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [2] + [0] + [0].
A list of available areas will display on the keypad.
Bosch Security Systems 04/12 BLCC600U
OK or MENU
MENU 1-8-2
MENU 2-0-0