Door Assignment; User Expire Date; Fingerprints - Bosch Solution 144 User Manual

Access > User Properties >

Door Assignment

This menu allows you to assign each user to one or more
access groups. An access group is used to allow and/or
restrict which users have access to various system outputs.
These outputs can be used to control door strikes, gates or
roller doors etc.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [1] + [4] + [5] and select the user
from the list then press [OK].
Ur1 John Smith
Ur2 Debbie Smith
Ur3 User 3 Name
Press

2. Use the up and down arrow keys to highlight the
Access Group then press the [ON] key to select or
the [OFF] key to deselect.
Door 1 Name
Door 2 Name
Door 3 Name
Press

3. Repeat Step 2 until all required Access Groups are
programmed, then press [OK] to save and exit or
press [MENU] to exit without saving.
Access > User Properties >

User Expire Date

This menu allows you to assign one or more users to expire
on a date in the future. This could be used when giving a
code to a tennant in a holday house etc. Once the expire
date is reached then all of the users credentials will cease
working and they will no longer be able to access the
system.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [1] + [4] + [6] and select the user
from the list then press [OK].
Ur1 John Smith
Ur2 Debbie Smith
Ur3 User 3 Name
Press

2. Use the [] and [] keys to program the month, day
and year. Use [] and [] keys to scroll cursor left
and right to between the month, day and year fields.
User Expire Date Ur1
Expire Date
01 Jan 2100
Press

3. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Bosch Security Systems 04/12 BLCC600U
MENU 1-4-5
OK or MENU
OK ON OFF MENU
MENU 1-4-6
OK or MENU
OK to SAVE

Fingerprints

The addition of the optional fingerprint reader to your
system allows you to turn areas on and off or to open a door
simply by presenting your fingerprint to the reader. The
following steps we help you to get the best performance
from your fingerprint reader.
1) When adding or enrolling fingerprints it is is important
to place and hold you finger in the correct position while
the system records the credential.
be placed so that the pad is making full contact with the
sensor. Do not use your fingertip.
2) Always try to present your finger in the same posistion as
you did when it was enrolled. Use the raised dimple on the
reader surface as a guide. People with smaller fingers may
find this dificult at first but with practice even they will be
able to use the reader.
3) The reader will vibrate as soon as it has completed
reading your fingerprint. Once you feel the vibrations you
should remove your finger.
4) If the reader fails on the first attempt, remove your finger
and wait for the large blue guide indicator to come on
before trying again. Whenever the reader is busy working
you may see the following screen on the keypad. Wait for a
few seconds before trying again.
Fr9 Unit Busy. Please try
later.
Press OK or MENU
4) In some cases the unit may not be able to read a finger
because the finger is cut or damaged by other means.
Extremely wet or dry fingers may also cause read errors but
these are rare. In this case you should revert to using your
PIN number on the standard keypad.
Figure 3: CM729B Fingerprint reader
Solution 144 User Guide
Your finger should
15