Quooker PRO3-VAQ E Installation Manual page 7

A
Drilling hole
• NOTE: The tap hole for the Nordic boiling-water tap should be 32 mm in
diameter. The Fusion tap hole should be 35 mm in diameter.
• For drilling the hole for the Fusion tap, see step 3 below.
• The Nordic boiling-water tap should ideally be positioned at the corner of the
sink to enable use above the sink or the work top.
• NOTE: It must be possible to move the spout of the Nordic boiling-water tap
freely up and down. When the spout is in its lowest position it projects ca.
25 cm below the work top. Bear this in mind when fitting the inlet combination,
sockets and the like.
• The Nordic boiling-water tap has a reach of 16 cm from the centre of the tap
hole – keep this in mind when choosing the tap position.
1 2
3
1 Select position
boiling-water tap
Select a suitable position for the
Nordic boiling-water tap based on the
type of sink and position of the mixer
tap.
2 Drilling hole for
boiling-water tap
Using the correct drill bit, drill a hole
of 32 mm through the work top for
the Nordic boiling-water tap.
NOTE: For the Nordic mixer tap
please refer to the separate guide.
In the case of a hole of 35 mm or
larger, use the centring ring provided.
3 Drilling hole for
Fusion tap
Select a suitable position for the
Fusion tap. Using the correct drill bit,
drill a hole of 35 mm through the
work top.