Quooker PRO3-VAQ E Installation Manual page 13

E
Connecting tank with Fusion tap
2
• The Quooker tank is supplied with a UK 3 pin plug and requires a standard
• If the mains lead is damaged it should be replaced by the manufacturer, their
• The light ring on the Fusion tap will light up to indicate when the water is
• The Q-shaped button on top of the tank is the on/off switch. Once the water
• Ensure that the tank has sufficient height clearance to avoid pinching the hose.
• Do not use any other washers or sealants than the ones supplied.
1
3
13 amp earthed socket.
agent or a qualified technician to prevent hazard.
being heated inside the tank. It will also light up when the tap is being
touched to indicate that it is a boiling-water tap.
is up to temperature the light on the tank will fade in and out.
2
14
4
1 Connecting tank
Place the tank in position and connect
the inlet hose to the inlet combination
with the large fibre washer supplied.
Connect the tap hose to the fitting at
the top of the tank using the small
washer and size 10 and 14 spanners.
2 Electrical
connection
Connect the boiling-water tap by plug-
ging the LED cable into the hole pro-
vided at the back of the tank cover.
Connect the tank to the socket. Switch
the socket on but not the tank yet.
3 Filling tank
Open the boiling-water handle (dou-
ble-push-and-turn) and the stop valve
on the inlet combination. Check for
leaks. Flush the tank through until the
water is clear. Black water will flow
out initially. This is Norit carbon from
the filter and completely harmless.
4 Switching on
tank
Switch on the tank. After the water
has heated up, the entire content of
the Quooker must be flushed out once
before use.