Grandstream Networks GXP1450 User Manual page 56

Public Mode
Public Mode Login Expiration
Settings -> Call Features
Off-hook Auto Dial
Off-hook Timeout
Intercom User ID
Disable Call Waiting
Disable Call Waiting Tone
Disable Direct IP Call
Use Quick IP Call mode
Disable Conference
Disable in-call DTMF Display
Enable sending DTMF via
Speed Dial
FIRMWARE VERSION 1.0.5.58
non-symmetric NAT routers work with STUN.
Configures to turn on/off public mode for hot desking feature on the
phone. If set to "Yes", users would need fill in the SIP Server address for
account 1 as well. Then reboot the phone. When the phone boots up,
users will need enter SIP User ID and Password on the LCD to login and
use the phone.
Note:
When the phone is in public mode login screen, press CONF button will
have the IP address of the phone displayed.
Expiration time is 0 to 24 hours. After time expiration, phone will auto log
out.
Configures a User ID/extension to dial automatically when the phone is
off hook. The phone will use the first account to dial out. The default
setting is "No".
If configured, when the phone is on hook, it will go off hook after the
timeout (in seconds). The default value is 30 seconds.
Configures the intercom extension number for account 1 to dial out (Not
applicable to GXP14xx). This User ID is mapped to the INTERCOM
button on the phone.
Disables the call waiting feature. The default setting is "No".
Disables the call waiting tone when call waiting is on. The default setting
is "No".
Disables Direct IP Call. The default setting is "No".
When set to "Yes", users can dial an IP address under the same
LAN/VPN segment by entering the last octet in the IP address. To dial
quick IP call, off hook the phone and dial #XXX (X is 0-9 and XXX
<=255), phone will make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet
mask. #XX or #X are also valid so leading 0 is not required (but OK). No
SIP server is required to make quick IP call. The default setting is "No".
Disables the Conference function. The default setting is "No".
When it's set to "Yes", the DTMF digits entered during the call will not
display. The default setting is "No".
Enables Multi Purpose Key to send DTMF during the call (Not applicable
to GXP14xx). The default setting is "No".
GXP2120/GXP2110/GXP2100/GXP14xx USER MANUAL Page 56 of 80