Configuring Nat Enabled With Pppoe; Step 1: Change Password - SonicWALL SonicOS Enhanced 2.2 Administrator's Manual

Configuring NAT Enabled with PPPoE

NAT with PPPoE Client is a network protocol that uses Point to Point Protocol over Ethernet to connect
with a remote site using various Remote Access Service products. This protocol is typically found when
using a DSL modem with an ISP requiring a user name and password to log into the remote server. The
ISP may then allow you to obtain an IP address automatically or give you a specific IP address.
1. Click the Setup Wizard button on the Network>Settings page.
2. Read the instructions on the Welcome window and click Next to continue.

Step 1: Change Password

3. To set the password, enter a new password in the New Password and Confirm New Password
fields. Click Next.
Page 18 SonicWALL SonicOS Standard Administrator's Guide