Creating Vpn Policies Using The Vpn Policy Window - SonicWALL SonicOS Enhanced 2.2 Administrator's Manual

__ Use this VPN tunnel as a default route for all Internet traffic
__ Destination network obtains address using DHCP through this VPN tunnel
__ Choose destination network from list
Primary IPSec Gateway/Secondary IPSec Gateway

Creating VPN Policies Using the VPN Policy Window

You can create or modify existing VPN policies using the VPN Policy window. Clicking the Add button
under the VPN Policies table displays the VPN Policy window for configuring the following IPSec Keying
mode VPN policies:
• IKE using Preshared Key
• Manual Key
• IKE using 3rd Party Certificates
Tip!
Use the VPN Planning Sheet for Site-to-Site VPN Policies to record your settings. These settings are
necessary to configure the remote SonicWALL and create a successful VPN connection.
Configuring a VPN Policy with IKE using Preshared Secret
To configure a VPN Policy using Internet Key Exchange (IKE), follow the steps below:
1. Click Add on the VPN>Settings page. The VPN Policy window is displayed.
2. In the General tab, select IKE using Preshared Secret from the IPSec Keying Mode menu.
3. Enter a name for the policy in the Name field.
4. Enter the host name or IP address of the remote connection in the IPSec Primary Gateway Name
or Address field.
5. If the Remote VPN device supports more than one endpoint, you may optionally enter a second host
name or IP address of the remote connection in the IPSec Secondary Gateway Name or Address
field.
Page 106 SonicWALL SonicOS Standard Administrator's Guide