Table of Contents
Advertisement
| Installing the Switch
C
2
HAPTER
Connecting to a Power Source
Check the the PWR LED indicator as the switch is powered on. If the PWR
10.
LED is not on, recheck the power supply and power cable connections at the
supply source and at power conversion module.
C
AC P
ONNECTING
To connect the switch to an AC power source:
First verify that the external AC power supply can provide 100 to 240 VAC,
1.
50-60 Hz, 0.65 A minimum.
Plug the power cable into a grounded, 3-pin, AC power source.
2.
For international use, you may need to change the AC line cord.
N
:
OTE
You must use a line cord set that has been approved for the receptacle
type in your country.
Insert the plug on the other end of the power cable directly into the
3.
receptacle on the switch.
After the power source is tuned on, set the power switch on the front of the
4.
switch to the ON position (marked "–").
Figure 12: AC Power Rececptacle
OWER
– 40 –
Advertisement
Table of Contents
