Rohde & Schwarz PR100 Manual page 241

R&S PR100
SYSTem
. :PRESet
. . :FACTory
Resets the device to factory settings by executing the command sequence:
• *RST
• STATus:PRESet
followed by resetting the following settings:
• IP Subnet mask (see SYST:COMM:LAN:SUBM)
• IP Address (see SYST:COMM:SOCK:ADDR)
• IP Port (see SYST:COMM:SOCK:PORT)
• DHCP state (see SYST:COMM:SOCK:DHCP:STAT)
• Clear memory lists: MEM:CLE 0, MAX
• Clear antenna lists:ROUT:PATH:DEL:ALL
• Clear suppress lists: TRAC:DATA SSTART, 0; TRAC:DATA SSTOP, 0
• Clear presets: PROG:PRES:DEL:ALL
• Clear UDP addresses: TRAC:UDP:DEL ALL
• Clear traces
Note that the security and password settings (SYST:SEC and SYST:PASS
subsystems) are not reset. Any device specific behaviour is described under
this same command in the specific documentation.
Parameters:
None
Example:
SYSTem:PRESet:FACTory
User Manual