SATO CL408e Service Manual page 164

Section 9. Optional Accessories
Label Dispenser Installation
STEP PROCEDURE
7. Install the magnetic catch for the front cover on the base of the
mainframe of the printer using the (2) self tapping screws. Attach
the strike plate to the front cover using the countersunk self
tapping screw. .igs. 9-16 & 9-17
8. Loosely attach (2) Pan Head Screws to the label drive assembly.
Attach the Label Dispenser Sub Assembly to the front of the label
drive by sliding the slotted openings of the Label Dispenser over
the screws. Tighten the screws. Verify that the drive gear is
properly meshed. .igs. 9-17 & 9-18
NOTE: Make sure that the Dispenser, when closed, does not contact
the Label Tear Off Plate. If it does, loosen the two screws on the Tear
Off Plate and move it upward. The Tear Off Plate must remain
horizontal.
9. Remove the Connector Cover (if installed) from connector slot
underneath the DSW2 and DSW3 switch access opening. Install
the interface cable in the slot. The connector is keyed and should
easily slide onto the pins. If the connector does not slide on easily,
verify you are installing the cable correctly and that there are no
bent pins on the connectors. .ig. 9-19
LOOSELY ATTACH (2) PAN
HEAD SCREWS FOR LABEL
DISPENSER ASSEMBLY
Fig. 9-17
Page 9-10
TEAR OFF PLATE
SATO CL408e/CL412e Service Manual
MUST REMAIN
HORIZONTAL
INSTALL MAGNETIC CATCH
WITH (2) SELF TAPPING
SCREWS
Fig. 9-16
INSTALL STRIKE
PLATE w/
COUNTERSUNK
SELF TAPPING
SCREW
PN 9001078
Rev. A