Replacing The Label Sensor Module - SATO CL408e Service Manual

Section 6. Replacement Procedures

6.12 Replacing the Label Sensor Module

After removing the Label Sensor Assembly from the printer, if the sensor module needs to be
replaced, do the following:
STEP PROCEDURE
1. Detach the paper guide from the side frame. .igs. 6-33
2. Remove the center screw holding the collar, spring, and washer to the sensor
mechanism.
3. Remove and replace the defective sensor module.
4. Reattach the label sensor assembly using steps in Section 6.11.
PAPER GUIDE
Page 6-26
PAPER GUIDE INSTALLED
COLLAR,
SPRING AND
WASHER
SENSOR MODULE
SATO CL408e/CL412e Service Manual
Figs. 6-33
PN 9001078
Rev. A