At/Atx Power Mode Select (Jpson); System Memory; Memory Installation Procedures - Advantech AIMB-281 User Manual

Intel xeon e3/ core i7/i5/i3/ celeron lga1155 mini-itx with crt/dvi/lvds, 6 com, dual lan, pcie x4

Hide thumbs Also See for AIMB-281:

Table of Contents

1.8.4

AT/ATX Power Mode Select (JPSON)

This jumper allows you to select ATX Mode or AT mode.

ATX MODE (Default)

1.9

AIMB-281 has two 204-pin memory sockets for 1066/1333/1600 MHz memory mod-

ules with maximum capacity of 16GB (Maximum 8GB for each DIMM). AIMB-281

supports only non-ECC DDR3 memory modules.

1.10

To install DIMMs, first make sure the two handles of the DIMM socket are in the

"open" position, i.e., the handles lean outward. Slowly slide the DIMM module along

the plastic guides on both ends of the socket. Then firmly but gently (avoid pushing

down too hard) press the DIMM module well down into the socket, until you hear a

click when the two handles have automatically locked the memory module into the

correct position of the DIMM socket. To remove the memory module, just push both

handles outward, and the memory module will be ejected by the mechanism.

AIMB-281 User Manual

AT MODE

Table of Contents