Messages; Operating Modes - Honeywell Tuxedo Touch Wi-Fi User Manual

Messages

The Tuxedo can record voice messages for others on the premises. The number of messages is not
limited; however, the total time of all messages added together cannot exceed 120 seconds.
Note: The voice messages are stored in the memory and all messages are lost if the keypad loses power
or if it is reset.
Recording/Retrieving Messages
Press the Multimedia
screen is displayed.
Press the RECORD
the keypad and speaking at a normal voice volume. As you are recording your message, the remaining
time counter counts down to indicate the total remaining time available and a
message is displayed above the message list window.
Press the STOP
icon when you are done recording the message.
To listen to a voice message, highlight the message and then press the PLAY
is being played, a
"Play (#): Voice Memo..."
Message LED continues to flash until all new messages have been played back entirely. When the end
of the message is reached, the playback stops.
To listen to the next message or previous message, press the NEXT
To delete the selected message, press the DELETE
Del Selected
To delete all messages, press the DELETE ALL
"Confirmation" Do you want to delete all messages? Select Yes or No.
To exit, press the Back
Notes:
1. Each message is numbered, dated and the length of the message in seconds (Sec) is displayed on the
message list.
2. Use the slide bar to raise and lower the message volume.

Operating Modes

Automation (Occupancy) Mode
This mode is primarily used with the Scenes features to automate certain scene actions and does not
communicate with the control panel.
Note: The Automation/Demo Mode option allows the automation and multimedia features to operate in
a non-security mode. When this option is selected, the keypad does not communicate with the
control panel and any user can select Advanced Setup screens.
Automation mode allows you to set Tuxedo in two conditions: Residential and Commercial. Scenes can
be set to trigger based on the status of these settings.
In Residential mode (default), the Arming options are: Home, Away, and Night.
About the System (cont'd)
a
nd Message icons. Enter your Authorized code; the "Message Center"
icon and record your message while staying within approximately one foot of
message is displayed above the message list window. The
Selected Memo 2: 11/02/12 00:30:00 Select Yes or No.
and Home icon.
and PREV
icon. A confirmation window is displayed stating:
icon. A confirmation window is displayed stating:
6
..."
"Recording New Memo
icon. As the message
icon.