Z-Wave Factory Default; Z-Wave Network Update - Honeywell Tuxedo Touch Wi-Fi User Manual

Using Z-Wave Devices and Scenes (cont'd)
Honeywell Thermostat
1. At the thermostat:
a) Follow the instructions in the thermostat Installation Guide under "Installer setup" to
"Remove a Z-Wave Network Connection."
b) When removal process is complete, press Done and the thermostat is removed.

Z-Wave Factory Default

Press the Automation
screen. Press the Z-Wave Factory Default
message is displayed:
"Warning Window"..."This Z-WAVE controller is about to be factory defaulted and will
lose all devices in the enrolled list." ... "All Z-WAVE devices must be re-enrolled after this reset."... "Each device
will have to be excluded before it can be re-enrolled."
Abort a Z-Wave Action
If you inadvertently make a wrong selection, (add, delete, or remove failed device) press the Abort
Operation icon to stop the process.

Z-Wave Network Update

After all Z-Wave devices have been successfully enrolled, you can perform a Z-wave Network Update to
individual devices or the whole network.
To perform an individual update, do the following:
Press the Automation
select a device and press the Search Devices
The message is displayed:
closer range of each other or try to add a repeater device to extend the range.
To perform a complete network update, do the following:
Press the Automation
the Scan icon. Tuxedo will scan the Z-Wave network and complete the discovery.
The message is displayed:
When done, the discovery result message is displayed:
discovery. See the device list for those devices. Try to add repeater devices to extend the range or move devices
closer to each other. Please run the discovery process again"
and Z-Wave Setup
icon to delete all devices from the controller. The
and Z-Wave Setup
or
"Update failed" "Update success."
and Z-Wave Setup
"Discovery is about to start please wait..."
icons to display the "Z-Wave Device Management"
Select Yes or No.
icons. At the Z-Wave Device Management list,
icon to perform an individual update for that device.
If the update fails, move device within
icons. At the Z-Wave Device Management list, press
"Discover Result ...
20
1 device(s) are not found during