Disconnecting Lan Cable - Toshiba TECRA A4 User Manual

User's Manual
If you are using Ethernet LAN (10 megabits per second, 10BASE-T), connect
with a category 3 cable, CAT3, or higher.
If you are using Gigabit Ethernet (1000 megabits per second, 1000BASE-T),
connect with a category 5e cable, CAT5e, or higher.
To connect the LAN cable, follow the steps below.
1. Turn off the power to the computer and to all external devices connected to
the computer.
2. Plug one end of the cable into the LAN jack. Press gently until you hear the
latch click into place.
LAN J
ACK
3. Plug the other end of the cable into a LAN hub connector. Check with your
LAN administrator before connecting to a hub.
NOTE: When the computer is exchanging data with the LAN, the LAN
active indicator glows orange. When the computer is connected to a
LAN hub but is not exchanging data, the Link indicator glows green.

Disconnecting LAN cable

To disconnect the LAN cable, follow the steps below.
NOTE: Make sure the LAN active indicator (orange LED) is out before
you disconnect the computer from the LAN.
1. Pinch the lever on the connector in the computer's LAN jack and pull out
the connector.
2. Disconnect the cable from the LAN hub in the same manner. Check with
your LAN administrator before disconnecting from the hub.
4-28
Figure 4-12 Connecting the LAN cable