Toshiba TECRA A4 User Manual page 10

Instructions for IC CS-03 certified equipment
1
The Industry Canada label identifies certified equipment. This certification
means that the equipment meets certain telecommunications network protec-
tive, operational and safety requirements as prescribed in the appropriate
Terminal Equipment Technical Requirements document(s). The Department
does not guarantee the equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to
be connected to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection.
The customer should be aware that compliance with the above conditions
may not prevent degradation of service in some situations. Repairs to certi-
fied equipment should be coordinated by a representative designated by the
supplier. Any repairs or alterations made by the user to this equipment, or
equipment malfunctions, may give the telecommunications company cause
to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground con-
nections of the power utility, telephone lines and internal metallic water pipe
system, if present, are connected together. This precaution may be particu-
larly important in rural areas.
CAUTION: Users should not attempt to make such connections them-
selves, but should contact the appropriate electric inspection authority, or
electrician, as appropriate.
2
The user manual of analog equipment must contain the equipment's Ringer
Equivalence Number (REN) and an explanation notice similar to the follow-
ing:
The Ringer Equivalence Number (REN) of the modem, which can vary. For
the REN of your modem, refer to your modem's label.
NOTICE: The Ringer Equivalence Number (REN) assigned to each ter-
minal device provides an indication of the maximum number of terminals
allowed to be connected to a telephone interface. The termination on an
interface may consist of any combination of devices subject only to the
requirement that the sum of the Ringer Equivalence Numbers of all the
devices does not exceed 5.
3
The standard connecting arrangement (telephone jack type) for this equip-
ment is jack type(s): USOC RJ11C.
The IC registration number of the modem is shown below.
10
Canada: 4005B-ATHENS