Led Explanation - TP-Link TL-WA860RE User Manual

TL-WA860RE

LED Explanation:


Name Status
Off
Blinking Green
Solid Green
Signal
Blinking Orange TL-WA860RE is connected to the router but is too far away from
Solid Orange
Off
Ethernet
Green
Off
Power
Orange
Green
RESET: This button is used to restore the Range Extender's factory default settings.

There are two ways to reset the Range Extender's factory defaults:
Option One: With the Range Extender powered on, press and hold the RESET button for 2
seconds. Wait 5 seconds until all the LEDs flash once. And then wait the Range Extender to
reboot to its factory default settings.
Option Two: Restore the default settings from "System Tools > Factory Defaults" of the
Range Extender's Web-based management page.
(RANGE EXTENDER/WPS): If your Wireless router or AP supports WPS or QSS

function, you can press the WPS or QSS button and then press the RANGE EXTENDER
button to establish a secure connection between the Wireless router (or AP) and the Range
Extender TL-WA860RE.
ON/OFF: The switch for the power.

ETHERNET: One 10/100Mbps RJ45 Ethernet port used to add wireless connectivity to an

Ethernet-enabled device such as Internet TV, DVR, Gaming console and so on. Please note
that this port is not allowed to be connected with router or AP.
300Mbps WiFi Range Extender with Power Outlet Pass-through
TL-WA860RE isn't connected to the router.
TL-WA860RE is connecting to the router.
TL-WA860RE is connected to the router and is in a good location.
the router.
TL-WA860RE is connected to the router but is too close to the
router.
No device is connected to ETHERNET port.
A device is connected to the ETHERNET port.
TL-WA860RE is off.
TL-WA860RE is booting.
TL-WA860RE is on.
Table 1-1
3
Indication