Panasonic VF0 Series 400V class Instruction Manual page 26

Operating with the operation panel - 1 (Factory setting state)
· Forward/reverse run operation:
· Frequency setting: Potentiometer setting (Parameter P09=0)
[Example for rotating in forward direction at operating frequency 25Hz]
Power ON
Run
command
Frequency
setting
[Stopping operation]
Stop
command
[Example for rotating in reverse direction at operation frequency 25Hz]
Power ON
Changing
the rotation
direction
Run
command
Carry out in the same manner as forward rotation [Frequency setting] ⇒ [Stop command]
[Changing the rotation direction during operation]
Use the same procedures as [Changing the rotation direction] explained
above.
In this case, when the SET button is pressed last the display will change to
the output frequency display, the motor will decelerate and then will start
rotating in the reverse direction.
25
Start/stop, rotation direction mode setting
(Parameter P08=0)
The main display lamp will turn ON.
RUN Press the RUN button.
The run state will be entered, but as the frequency setting
dial is set to Min., the 0V stop state will be entered.
Gradually turn the frequency setting dial clockwise.
The motor will start rotating, and will reach 25Hz
operation when 25.0 is displayed.
Press the STOP button.
STOP
The motor will start to decelerate and will stop in
approx. 2.5 seconds.
The main display lamp will turn ON.
Press the MODE button.
MODE
MODE Press the MODE button.
Press the SET button. (The main display will flicker)
SET
Press the
Press the SET button to set the data.
SET
Press the RUN button.
RUN
The run state will be entered, but as the frequency setting
dial is set to Min., the 0V stop state will be entered.
(up) button. (The main display will flicker)
Main display
0 0
0
0. 0
0
2 5.
0 0 0
0 0 0
F r
d r

L F

L r
0 0 0
0. 0